Guide on How to Take Off Old Skirting Boards from the Floor



Skirting board removal is quick and easy with the correct equipment and knowledge. This manual will demonstrate how to chisel the skirting free and then pry it off with a wrecking bar. Additionally, it will provide advice on safeguarding the wall’s surface to prevent damage. When remodeling, replacing old skirting boards with new ones can be more straightforward and faster and give a better finish than fixing, sanding, patching, and painting existing skirting boards.

Step 1- Look for Obstacles

Check around the skirting first because you’ll be using sharp instruments. The skirting boards you are removing could be concealing wires if they were put up more recently. In more recent boards, which come in a wide range of varieties with over 100 skirting board designs in the market, there may be a rebate that can be utilized to conceal wiring. Remember that the wires may not be visible from the outside when attempting to peel the skirting away from the wall.

Step 2 – Skirting Boards Loosening

It would be best if you now used the Stanley blade. The top of the skirting near the wall must be running along with the sharp edge. Doing this first ensures that the paint won’t come off the wall when you remove the skirting. Additionally, it shatters the bond that decorators’ caulk had made between the wall and the board. This is usually utilized while decorating to provide a neat finish and fill any minor gaps that could be present and appear unattractive.

The hammer and the chisel must then be used. Gently tap the chisel between the skirting and the wall with the hammer. This aids in releasing it from the wall. Use this method and work your way from one end to the other.

Step 3 – Getting the Skirting from the Wall by Prying Them

You may remove the skirting board from the wall after it has been thoroughly loosened. It’s possible that the current skirting was bolted, glued, or fastened to the wall. For this, you’ll need a crowbar or chisel. To prevent damage to the wall when using the crowbar behind the skirting, place a block of wood between it and the wall—this aids in distributing the pressure across a larger surface area to lessen the likelihood of injury.

You should be able to insert your selected tool between the top of the skirting and the wall by lightly hammering with a hammer. This will assist in loosening the board as much as possible. Repeat every six inches along the wall. The board should come away quickly once the nails have been removed from the wall.

Step 4 – Take out Any Left behind Nails

Once you’ve taken out all the skirting, it’s conceivable that some of the nails (or pins) may remain on the walls. If so, be prepared to remove them by having your pliers at the ready. You should firmly grasp the nail you need to take out with your pliers. Use a light pulling motion.

If you can’t release them with pliers, a claw hammer should be able to accomplish the trick. You should hammer the nails flush into the wall if they can’t be withdrawn quickly. This will shield the plaster from harm and let you install the new skirting precisely. Be cautious since there’s a risk that a pipe or cable might be concealed in this wall.

Step 5 – Before Installation, Clean the Area

After removing the skirting boards, give the area thorough cleaning. When performing this type of labor, all kinds of risks might be left behind; cleaning the area can prevent any accidents. Keep an eye out for detritus, such as sharp nails and cracked wood pieces. After reading this article, you ought to feel comfortable taking any kind of skirting off among the over 100 skirting board designs available.

Compare listings